Model-specific code library

Electrolux oven Door lock codes

7 printed codes in this group: F102, F50, F90, F91-F94, F95, F96, F97.

Top of a wall oven opening with the door lowered, showing the latch motor and metal hook, with the power cord plug lying unplugged on the floor.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Door lock codes

F102

F102 comes from Electrolux's UK and Australian support pages, and no US Electrolux document we found lists it. Those pages describe a door lock sensor problem: close the door fully, disconnect power for a few minutes and try again.

Model-dependent / read first
F50

F50 is an A/D out of range error on Electrolux's modular wall oven control: the oven relay board cannot read the status of the switches, such as the door switch and the lock motor switch. Reset power; if F50 returns, book a technician.

Technician
F90

F90 on an Electrolux oven is a door lock motor mechanism failure. The ES630 sheet says door motor mechanism failure, and the modular sheet says the control does not see the lock motor running. Press UNLOCK if the door is locked, then reset the power.

Model-dependent / read first
F91-F94

The Owner Center oven guide lists F90 through F94 as one door lock issue and gives UNLOCK steps. The ES630 and modular sheets print only F90. Press UNLOCK, follow the screen, reset the power for up to 30 seconds, and book a technician if it returns.

Model-dependent / read first
F95

F95 is a motor door lock mechanism failure on Electrolux's modular wall oven control: the lock motor does not stop running, or the lock switch sends an invalid signal. Reset power; if F95 returns, book a technician.

Technician
F96

F96 means the oven door was detected open during a self clean cycle, on Electrolux's modular wall oven control. The sheet says the door switch lost contact. Make sure the door closes fully and nobody pulls on it during the cycle.

Owner checks first
F97

F97 is an MDL invalid state on Electrolux's modular wall oven control: the oven relay board sensed the motor door lock in a state it should not be in. Take the oven off power for half a minute, then reconnect it; if F97 returns, the sheet replaces the motor door lock.

Technician

Let’s take care of it.

Premium appliances deserve
careful service.