Inside the appliance
Wall oven user interface board (modular control). In plain English.
The oven user interface board, the UI or UIB, is part of the modular electronic oven control on a 2017 Electrolux wall oven. It connects the touch panel, knobs and display to the oven relay board. The service sheet names it for F03, F12, F16, F17, F19 and F22. Owners reset power for 30 seconds.

Where it fits.
Wall oven user interface board (modular control) in the appliance
Behind the control panel; the sheet does not locate the board.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Wall oven user interface board (modular control) concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Reset the power
Disconnect power, wait 30 seconds and reapply it. This is the sheet's first step.
- 2
Watch the power-up
The sheet says a code that returns at power-up points to the control assembly.
- 3
Turn the knobs to OFF
For F16, turn both knobs fully to OFF before the reset.
- 4
Keep the panel clear and dry
Wipe the glass dry and clear anything resting on it.
- 5
Leave the boards alone
The sheet says the individual boards are not field repairable and that the oven control is not field-repairable.
Cleaning or replacement?
Leave internal testing to a technician.
F03, F12, F16, F17, F19 or F22 returns after the 30-second reset.
The code appears every time the oven powers up.
The touch panel does not respond.
Arrange a diagnosticSources and model boundaries.
These sources back the Wall oven user interface board (modular control) guidance. Use the manual for your own model.
- Service Data Sheet, p/n A00980644, "Electric wall ovens with modular oven controls"
Follow the guide for your exact model. Consult how we research these pages.
What is the user interface board?
It is one of the boards in the modular oven control. Oven functions run through the user interface and an oven relay board.
What does F22 mean?
A communication failure between the oven user interface board and the oven relay board. Leave the oven without power for 30 seconds, then restore it.
What does F16 mean?
The user interface board cannot read the two control knobs. Turn both fully to OFF and cut power for 30 seconds.
Can I swap the board?
No. The sheet says to verify the proper relay board, user interface board and touch panel for the model number. Book a technician.
Does this apply to every Electrolux oven?
No. The ES630 control on older ovens differs, and F15 means something else there. This sheet covers the 2017 modular control.
Codes, symptoms, parts and service
Link the message to what to do next.
F01-F05
F01, F02, F04 and F05 are touch panel failures on Electrolux's modular wall oven control, and F03 means the user interface board is incorrectly configured. Leave the breaker off for 30 seconds before turning it on again. If the code returns at power-up, book a technician.
Electrolux oven clock, timer or display problems
The written Electrolux articles say little about setting the clock or timer, since its display-settings guide is a video. What they do cover is a display or keypad that acts up: a stuck key (F11), memory and cable errors (F13, F14, F15), Demo mode and a power reset.
Oven repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.


